The optimum solution to prepare your final mix for cd mastering is to ensure that the levels are not excessive and that you don’t have clipping on the audio track. Clipping takes place when the audio levels getting mixed in to the output channel lead to higher than normal levels, which, in digital audio, merely become trimmed off on the zero attentuation point (clipped). The easiest way to ensure that you will not have this condition is to keep to the following recommendations.When you are prepared to start with your mix, confirm your monitor system, amplifier, earphones or laptop sound system, or whatever it is you employ to hear your track as you mix, is cranked up all the way. After that, move to your mixing board and solo out a single track, such as the kick drum, and then drag it’s slider pretty much all the way down. Subsequently, view the main output bus slider and make certain it is all the way up to the zero attentuation point. At this point run the song and gently turn up the bass drum track slider until you can hear the part clearly. You shouldn’t really need to turn it up very high for you to hear it ok, given that you currently have your monitor unit cranked all the way up. Now, 1 by 1, very carefully add the other tracks and slowly increase their sound level until eventually you can hear them all well. Just as before, you won’t need to push the sliders up very far, because your playback system is on full volume.As soon as you have your track mixed using the preceding guidelines, you’ll be able to output your song at a level that will not clip the output channels, and definitely will feature a great deal of headroom. The result should be a clean, punchy master, after the track is delivered to our cd mastering studios and our technicians do their valuable magic.